ICND1 break down - Operation of CSMA/CD

Back>


CSMA/CD - Stands for carrier-sense multiple access with collision detection, which describe how the Ethernet protocol regulates communication among nodes. In the earlier days, all the Ethernet components were the network Interface cards (NIC) and coaxial cable connecting them. In case two NICs are sending message at the same time, the message will be corrupted. CSMS/CD avoided this.

When a NIC has data to transmit, the NIC first listens to the cable to see if a carrier signal is being transmitted by another node. A carrier signal in its physical form is a current flowing in the cable (each bit corresponds to 18-20 mA). Data is only sent when no carrier is observed -- the so called carrier-sense multiple access (CSMA).

CSMA have a weak point -- If two NICs simultaneously try transmit, then both could see no carrier signal in the medium, thus decide to transmit and a collision will occur.  Collision Detection (CD) resolved this problem. When there is data waiting to be sent, each transmitting NIC will observe if a collision occurs (excess current i.e. >24mA for coaxial Ethernet). If  collision is detected, it stops transmission and sends a 32-bit jam signal instead. The receiving NIC will discard the corrupted frame due to the jam signal. After sending the jam signal, each of the NICs will wait a random amount of time before beginning transmit again. The random time make sure the two NICs will not transmit simultaneously again.

comments link

ICND1 and ICND2 break down

1 comment:

  1. [...] The mallest packet size is defined in RFC document (RFC894), I don’t know why IEEE like the number 64. As far as I concern, physics set a low bound for the packet size. Ethernet LANs use CSMA/CD, all nodes shared a single coaxial cable and only one speaker is allowed at a time. Packets had to be of a minimum size to guarantee that the leading edge of the propagating wave of the message got to all parts of the medium before the transmitter could stop transmitting, thus guaranteeing that collisions would be discovered. If you don’t understand the short answer, let’s review what we have learned in operation of CSMA/CD : [...]

    ReplyDelete